Installing Ikea Bathroom Vanity

Jan 10th

Ikea Bathroom Vanity with Granite bathrooms is becoming increasingly popular. They can be installed on all vanity and can contribute to the natural beauty of the toilet. One of the advantages of a stone vanity top, such as granite, is the ability to use an undercount sink. Undercount sinks not only give vanity a more streamlined look, they can also help keep the disk clean, allowing you to shoot debris from the counter in the sink. To install a granite counter on your vanity, install the sink first.

Instructions

Measure area where the vanity will be installed and find the center line for the drain. This allows you to place vanity properly. Keep in mind that the granite countertop will hang Bathroom Medicine Cabinets Ikea with half inches on each side. If you install vanity next to a wall and it has a filler strip or thin piece of wood to fill the gap between vanity and the wall. Place vanity on the wall. Make sure that the back is accessible to the drain pipe and water supply. If necessary, use a hand-held jigsaw to cut out holes for plumbing. Place jigsaw to wood on level with water supply and drainage pipes.

READ  Some Ideas to Simply Home Depot Bathroom Vanity

Press the saw in a circle large enough for these pieces to fit through. Do not worry about making the circles the same size as plumbing will cover them. Turn the granite countertop up and down and install the faucet. Use an Allen key to remove the top of the crane, and then push the crane stems through the holes. Replace the crane tops and tighten them with hex wrench. Run a rigid silicone seal around the gap for disc cut. Silicone seals are contained in a clamp tube; just drive a thin line of it around the opening so that the sink’s edge can sink into it. Do not squeeze too much in any area as the pressure from the sink is out.

Center the zinc over the opening and press it tight. Install the mounting clip on the edge of the sink, next to the bolt shaft, secure it with epoxy. Wait ten minutes for the epoxy to adjust and then tighten the clamp and bolt stem by screwing the bolt down with a wrench. Does not use the bolt or it can crack granite. Test fit granite slab over vanity. There should be a 1/2-inch granite overlay on each side, and a 1-inch overhang in the back. Move Bathroom Cabinets Ikea along the wall needed to fit. Use a drill to screw the vanity on your back to a stud in the wall to hold it in place. If necessary, use a control detector to locate the stud, move the device along the wall until it indicates that it has detected a stud.

READ  Modern Bathroom Vanity Remodeling Your Bathroom for the Future